2008 Harley Davidson FXDL Low Rider (Lowrider) Service Manual


 

2008 FXDL Low Rider Service Manual

 

DOWNLOAD MANUAL BELOW
 
 
 
INTRODUCTION
 
This 2008 FXDL Harley Davidson Dyna Low Rider service manual download describes the service procedures for the complete motorcycle. Follow the Dyna maintenance schedule recommendations to ensure that the chopper is in peak operating condition and the emission levels are with in the standards set by states/county Resources Board. Performing the scheduled maintenance on your Dyna is very important. It compensates for the initial wear that occurs during the life of the bike.
 
All chapters in this Harley Dyna 2008 service manual applies to the whole motorcycle and illustrates procedures for the removal and installation of components that are in a detailed step-by-step fashion.
 
Most all HD (H-D) 2008 Dyna FXDL Low Rider (Lowrider) service manual chapters start with an assembly or systems illustration, diagrams, exploded parts view, quality pictures, service information and troubleshooting for the section. The subsequent pages give detailed service/repair procedures. If you don't know the source of the trouble, go to the troubleshooting page for a list of causes and effects to determine the problem.
 
 
Popular Dyna Searches:
 
2008 Harley Davidson FXDL Low Rider Service Manual
2008 Harley Dyna Lowrider Repair Manual
08' Dyna Low Rider Repair Guide
FXDL Dyna Service Manual 08'
Low Rider Service Manual 08
Owner's Repair Guide for 2008 Low Rider
Users Harley Tech Instruction Book for Dyna 2008
Repair Book for Dyna Low Rider


OTHER HARLEY DYNA SEARCHES:

INTAKE LEAK TEST

GENERAL

NOTES

• To prevent false readings, keep air cleaner cover installed when performing test.

• Do not direct propane into air cleaner; false readings will result.

• Be careful when testing vehicle with air cleaner assembly. This type of air cleaner has an open backing plate. Even with air cleaner cover on, directing nozzle too close to backing plate can give false readings.

1. Make sure valve knob (6) is closed (fully clockwise).

2. Screw valve assembly (5) onto propane bottle (1). Tester Adjustment

1. Press and hold trigger button (8).

2. Slowly open valve knob (6) until pellet in flow gauge (7) rises to between 5 and 10 SCFH on gauge.

3. Release trigger button.

1. Propane bottle
2. Nozzle
3. Copper tube
4. Hose
5. Valve assembly
6. Valve knob
7. Flow gauge
8. Trigger button
9. Hanger

Leak Tester

PROCEDURE

1. Start engine.

2. Warm up engine to operating temperature.

NOTE

Do not direct propane stream toward air cleaner. If propane enters air cleaner, a false reading will be obtained.

3. Aim nozzle (3) toward possible sources of leak such as intake manifold mating surfaces.

4. Press and release trigger button (2) to dispense propane. Tone of engine will change when propane enters source of leak. Repeat as necessary to detect leak.

5. When test is finished, close valve knob (turn knob fully clockwise).